Hercus way felt retaining screw--part No.16b, 5h711
$0.60
Hercus 9 and 260 way felt retaining screw--part No.16b, 5h711price is for one...
motor forward- reverse switch--part No.QS-15
$24.50
motor forward- reverse switch--part No.QS-15 although the main photo doesn't show it, the handle..
NEW Hercus gearbox handle idler bearings---part No.5H557
$12.00
new Hercus gearbox handle idler bearing---part No.5H557 Needle roller bearing, inner and outer ..
NEW Hercus 260 roll pin for micro switch rod---part No.5H290
$0.50
NEW Hercus 260 roll pin for micro switch rod---part No.5H290..
NEW roll pin for hercus leadscrew washer----part No.5H54
$0.50
NEW roll pin for hercus leadscrew washer----part No.5H54..
NEW 6203-2RS bearings for Hercus 260 and 9 countershaft----part No.5H206, M66
$6.00
NEW 6203-2RS bearing for Hercus 260 countershaft----part No.5H206 rubber sealed bearing, removab..
new mt3-mt2 reducer sleeve for Hercus 9 headstock----part No.AS-32
$26.00
new mt3-mt2 reducer sleeve for Hercus 9 headstock----part No.AS-32..
Hercus 260 G countershaft bearings----part No.ABP0015
$8.00
6202-2RS, rubber sealedbearing seals can be removed if requiredsale is for 2 ..
Hercus 260 G front input bearing----part No.abp0011
$3.60
Hercus 260 G front input bearing----part No.abp0011rubber seals can be removed if required.price is ..
hercus 260 G rear input bearing---part No.ABP0039
$6.00
hercus 260 G rear input bearing---part No.ABP0039rubber seal can be easily removedprice is for 1...
key for drive shaft----part No.337, 337a
$2.00
Woodruff key for drive shaft----part No.3371/8 thick x 5/8 diapart No.337a, 3/16 thick x 5/8 Dia. ca..
D-Bit grinder---dbg-01
$1,395.00
Bench top Universal d-bit grinderuseful for sharpening drill, lathe tools and milling cuttersI am lo..
Flat ribbed belt for early Hercus 9----part No.M31
$25.60
Flat belt for early Hercus 9this belt is 92cm or roughly 36 inches.just over 7/8 wide.reinforced rib..
small drill chuck mounting arbor MT2-B10----part No.A2b10
$9.50
small drill chuck mounting arbor MT2-B10handy for testing tailstock alignment...
NEW REPLACEMENT PARTS- HERCUS LATHES (398)
New & Used Machine Parts-- HERCUS, SHERATON, SOUTH BEND (508)
BEARINGS (12)
ELECTRIC MOTORS (9)
general engineering (16)
Hercus 0 Mill parts (24)
LATHE GEARS (87)
LATHE TOOLING (56)
MACHINE PLATES-THREADING, SPEEDS, FEEDS, ETC (23)
MILLING TOOLS (2)
PUBLICATIONS (11)
South Bend GS26 New parts (22)
SPECIAL TOOLS FOR HERCUS LATHES (2)
V-BELTS & PULLEYS (19)
SECONDHAND MACHINERY (1)
PRIVATE SALES (0)